Letters Master - brushed size 2,5 cm to 8 cm
Brass tombstone letters in Pilla finish / brushed.
| Finish / Color | Pilla - brushed |
| Material | Brass |
| Dimensions | height: 2.5cm, 3cm, 4cm, 5cm, 6cm and 8cm - alphanumeric characters (letters) height: 2.5cm, 3cm - numeric characters (numbers) height: 2.5cm, 3cm - special characters (cross, star, ...) |
| Installation | Mounting pin on the back (drilling is required) |
Letter Installation
The letters and signs have pins on the back side for which it is necessary to drill two holes (hooks and special signs can have only one pin) with a diameter of approx. 2-3 mm.
To make your work easier, you can use the P.Script program downloaded here (.rar file) to create a template that allows you to accurately position the letters on the stone. Sample template can be viewed here.
How to install:
1. Cut out the desired texts from the paper template
2. Glue the template (or cut strips) to the stone with adhesive tape
3. Use a point tool to make a pin mark
4. Drill holes in the marked places
5. Fill the holes up to 70-80% with glue
6. Lay the letter on the stone - align if necessary
7. Allow the adhesive to dry - follow the manufacturer's instructions
Installation in picture:
Removing letters:
If you want to remove the inscription or. letters the procedure is as follows:
1. Heat the letters with an industrial heater
2. Carefully lift the edge of the letter with a paint spatula
3. Use protective equipment when working - letters and glue can be hot!
Removing letters in picture:
ATTENTION!
Do not use aggressive acid adhesives!
Handle the signs with extreme caution - painted metals are extremely sensitive!
A collision or a strong hit can damage the protective layer of paint or varnish which will greatly increase the possibility of oxidation!
